Some uses of radioactivity: in industry
To control the thickness of metal or paper
Radioactive sources are used in industry to control the thickness of metal or paper as it is rolled into thin sheet.
An Materials that send out energy. is placed on one side of a sheet and a Sensor that measures a physical quantity and sends a signal to a meter to gain a measure of the quantity. on the other.
If the thickness of the sheet remains constant the activity will not change.
If there is a change in thickness, the activity increases or decreases.
This can trigger the rollers to squeeze harder or less hard to maintain the correct thickness.
A beta source is used because beta radiation can penetrate paper or thin aluminium, but the amount of penetrating will vary sufficiently as thickness changes.
The source should have a long The half-life of a radioactive source is the time taken for its activity to fall to half of the original activity. Half-life is measured in seconds. so that the count rate remains almost constant each day and so that it does not need to be replaced too frequently.
To check for leaks in water pipes
Water supplies can be contaminated with a gamma-emitting radioactive source to find leaks in pipes.
Where there is a leak, contaminated water seeps into the ground, causing a build-up of gamma emissions in that area.
The build-up of gamma emissions can be found using a Device used to detect and measure the quantity of ionising radiation in an area..
This makes it easier to decide where to dig to find the leak without having to dig along the whole length of the pipe.
The radioactive source used for this purpose must:
- be a gamma emitter to penetrate the ground and road surface;
- have a half-life of at least several days to allow the emissions to build up in the soil but not too long so that exposure is limited as it will form part of the water supply.